内增湿式质子交换膜燃料电池堆动态传热模型

黄 敏; 李兴虎

内增湿式质子交换膜燃料电池堆动态传热模型

黄敏,
李兴虎

北京航空航天大学交通科学与工程学院, 北京 100191

基金项目: 汽车安全与节能国家重点实验室开放基金资助项目(KF2005-010)

详细信息

作者简介:
黄敏(1981-),男,湖北咸宁人,博士生,huangm@ae.buaa.edu.cn.

中图分类号: TM 911.4
计量
- 文章访问数: 3036
- HTML全文浏览量: 185
- PDF下载量: 1041
- 被引次数: 0
出版历程
- 收稿日期: 2008-04-01
- 网络出版日期: 2009-04-30

Transient heat transfer model of proton exchange membrane fuel cell stack with internal humidification

School of Transportation Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 建立了质子交换膜燃料电池阴极的传质模型,综合考虑了影响电堆传热的多个因素,在此基础上针对内增湿式燃料电池堆建立了动态传热模型.采用Runge-Kutta-Felhberg法对模型进行求解,对电流、反应物过量系数、压强、冷却水流量等对电堆温度的影响进行了研究.结果表明,当电流大于25A时电堆温度将不能自行稳定在80℃以下,采用水冷可以有效地将电堆温度控制在较理想的范围内.在额定功率为5kW的燃料电池堆试验台架上进行了热管理试验,试验结果同模型预测值吻合较好.
- 质子交换膜燃料电池 /
- 动态分析 /
- 传热
Abstract: A transient heat transfer model of proton exchange membrane fuel cell (PEMFC) stack with internal humidification,based on mass transportation phenomena in cathode,was developed. Factors affecting the stack temperature were considered. Equations were solved with Runge-Kutta-Felhberg method. Results indicate that the stack temperature can-t be maintained below 80℃ itself when current exceed 25A. Influence of current,pressure,stoichiometric ration and water flow rate on stack temperature were researched as well. Heat management tests were carried out on a 5kW PEMFC stack,and a good agreement was found between tests and model prediction.
- proton exchange membrane fuel cells(PEMFC) /
- transient analysis /
- heat transfer

HTML全文

参考文献(1)

[1] 黄敏,李兴虎.质子交换膜燃料电池堆电气性能试验研究[J].电源技术,2007,31(5):361-363 Huang Min,Li Xinghu. Experimental research on the electric performance of proton exchange membrane fuel cell stack [J]. Chinese Journal of Power Sources,2007,31(5):361-363(in Chinese) [2] Lee J H,Lalk T R. Modeling fuel cell stack system [J]. Journal of Power Sources,1998,73:229-241 [3] Amphlett J C,Mann R F,Peppley B A,et al. A model predicting transient responses of proton exchange membrane fuel cells [J]. Journal of Power Sources,1996,61:183-188 [4] 邵庆龙,曹广益,朱新坚.质子交换膜燃料电池电堆动态热传输模型[J].上海交通大学学报,2004,38(8):1300-1303 Shao Qinglong,Cao Guangyi,Zhu Xinjian. Heat transport dynamic model of proton exchange membrane fuel cell stack [J]. Journal of Shanghaijiaotong University,2004,38(8):1300-1303(in Chinese) [5] Beining T,Lu D M,Djilali N. Three-dimensional computational analysis of transport phenomena in a PEM fuel cell [J]. Journal of Power Sources,2002,106:284-294 [6] Ceraolo M,Miulli C,Pozio A. Modelling static and dynamic behavior of proton exchange membrane fuel cells on the basis of electro-chemical description [J].Journal of Power Sources,2003,113:131-144 [7] Cheddie D,Munroe N. Mathematic model of a PEMFC using a PBI membrane[J]. Energy Conversion and Management,2006,47:1490-1504 [8] 黄敏,李兴虎.质子交换膜燃料电池的参数模型及实验验证[J].武汉理工大学学报,2008,30(6):110-113 Huang Min,Li Xinghu. Parametric modeling and experimental evaluation of a proton exchange membrane fuel cell stack [J]. Journal of Wuhan University of Technology,2008,30(6):110-113(in Chinese)

施引文献

资源附件(0)

访问统计