北京航空航天大学学报 ›› 1998, Vol. 24 ›› Issue (5): 533-537.

• 论文 • 上一篇    下一篇

挤压油膜阻尼器失效分析方法

刘方杰   

  1. 北京航空航天大学 动力系
  • 收稿日期:1997-09-22 发布日期:2010-11-18
  • 作者简介:男 69岁 教授 100083 北京
  • 基金资助:

    航空科学基金(94B51089)资助项目

Methods of Analysis Failure of Squeeze Film Damper

Liu Fangjie   

  1. Beijing University of Aeronautics and Astronautics,Dept. of Jet Propulsion
  • Received:1997-09-22 Published:2010-11-18

摘要: 着重论述分析挤压油膜阻尼器失效的方法. 首先介绍了国际上主要的航空发动机制造厂家对挤压油膜阻尼器的研究, 那些厂家是General Electric公司、Pratt & Whitney公司和Rolls Royce公司.这不仅有助于我国研制挤压油膜阻尼器的工作,同时也提出一种启示, 研究挤压油膜阻尼器的失效, 应基于综合性参数的选配. 因此,用了轴承参数B和质量偏心率U为基本参数,来说明分析失效的方法.并定义了两种失效的情况,一是转子系统过不了临界转速,二是出现双稳态特性.作出了过不了临界转速的特性图,并带有数据,还提供了3种典型的双稳态特性曲线和产生双稳态特性的数据点.

Abstract: The methods of analysis failures of squeeze film damper are emphasis on expounded.First, the studies of squeeze film damper of the principal aeroengine manufacture factories in the international have been introduced. It is not only to help the envelopment of squeeze film damper for China but also it raises an inspiration that is to research the failure of squeeze film damper should be based on the collocations of synthetical parameters. Thus the bearing parameter B and unbalance eccentricity ratio U are used as the elementary parameters to detail the methods of analysis failures. There are two cases to define the failure . One is the rotor system can not to strit over the critical speed ,and the other is arising the bistable characteristic. The data and character diagram of unable to strid over critical speed ,and three typical bistable curves have been presented.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发