北京航空航天大学学报 ›› 2004, Vol. 30 ›› Issue (07): 606-609.

• 论文 • 上一篇    下一篇

预拉伸板轧制-拉伸残余应力的计算机仿真

赵丽丽, 张以都   

  1. 北京航空航天大学 机械工程及自动化学院, 北京 100083
  • 收稿日期:2003-04-11 出版日期:2004-07-31 发布日期:2010-09-21
  • 作者简介:赵丽丽(1977-),女,山东威海人,博士生, lily buaa@sohu.com.
  • 基金资助:

    十五航空基金资助项目

Computer simulation of residual stress for cold rolling prestrectching board

Zhao Lili, Zhang Yidu   

  1. School of Mechanical Engineering and Automation, Beijing University of Aeronautics and Astronautics, Beijing 100083, China
  • Received:2003-04-11 Online:2004-07-31 Published:2010-09-21
  • Supported by:

    十五航空基金资助项目

摘要: 为消除铝板冷轧过程中产生的残余应力,采用弹塑性大变形有限元法对变形区内残余应力的分布进行数值模拟.通过分析不同轧制工况对残余应力分布的影响,得到不同压缩量对轧制残余应力的影响; 并对不同轧制工况后的板材进行参数拉伸,得到拉伸力大小、拉伸变形量大小对残余应力消除效果的影响值.模拟结果表明适当的拉伸(2%左右)可以均匀细化、部分消除残余应力,减小残余应力对后续加工的影响.

Abstract: To eliminate the residual stress formed during the process of Al board cold rolling, the distribution of stress in the deformation region was stimulated by elas-plastics large deformation finite element analysis. Analyzing the effects towards residual stress from different rolling loadcase, the value of cold rolling residual stress caused by different compress was gotten; Analyzing parameters stretching toward different rolling loadcase board, the effect of the residual stress elimination influenced by stretching force and stretching deformation was figured out. The simulative results show that the method of the proper stretching (about 2%) can evenly and partly eliminate the residual stress, reduce the effect toward the following manufacture induced by the residual stress.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发