北京航空航天大学学报 ›› 2011, Vol. 37 ›› Issue (6): 658-664.

• 论文 • 上一篇    下一篇

基于Z网络的升降压DC/DC变换器

齐铂金, 杜青, 张瑾, 马骏   

  1. 北京航空航天大学 机械工程及自动化学院, 北京 100191
  • 收稿日期:2010-04-29 出版日期:2011-06-30 发布日期:2011-07-05
  • 作者简介:齐铂金(1963-),男,湖南湘潭人,教授,qbj@buaa.edu.cn.
  • 基金资助:

    国家863计划资助项目(2006AA11A145)

Novel buck-boost converter based on Z-source

Qi Bojin, Du Qing, Zhang Jin, Ma Jun   

  1. School of Mechanical Engineering and Automation, Beijing University of Aeronautics and Astronautics, Beijing 100191, China
  • Received:2010-04-29 Online:2011-06-30 Published:2011-07-05

摘要: 基本的非隔离型升降压电路存在由二极管反向恢复带来的短路环问题.设计了一种基于Z网络的升降压DC/DC变换器,从电路结构上避免了短路环的存在,分析了Z网络和变换器的初始态阶跃响应,并设计了预充电电路,消除了变换器启动时的电压和电流尖峰,讨论了工作在电感电流连续模式(CCM, Current Continuous Mode)下的3种开关模态并分析了其工作原理,依照效率最优原则对升压和降压模式的开关模态进行简化,从而优化了变换器的控制方法,提出了一种通过合理选择电感电流纹波系数确保变换器工作在CCM模式下的方法,给出了各元器件的设计规则,并通过仿真和实验加以验证,结果与理论分析相吻合.

Abstract: Basic non-isolated buck-boost circuit exists the problem of short-circuit ring caused by the diode-s reverse recovery. A buck-boost DC/DC converter based on Z-sourse was designed. The presence of short-circuit ring was avoided from the circuit structure. The step response of initial state of the Z-network and the converter were discussed. The pre-charge circuits was also designed. The voltage and current spikes when the converter started were also eliminated. The three operation modes and operation theory of the converter was analysed when it worked in the situation of inductor current continuous mode(CCM). The operation modes of the boost and buck mode were simplified according to the principles of optimal efficiency, thereby the control strategy was also optimized. A method was presented to ensure the converter worked in CCM through choosing the reasonable inductor ripple factor. The design rules of the components was also given. Smulation and experimental results coincide with the theoretical analysis.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发