Collision and attachment behavior between rising bubble and plastic plate in pure water
-
摘要:
为了揭示气泡尺寸和表面疏水性对塑料浮选过程的影响规律,采用高速摄影技术观测上升气泡与塑料平板在纯水介质中的碰撞黏附行为。根据气泡速率的变化情况,将碰撞黏附行为细分为碰撞、液膜排液、三相接触线扩散等3个阶段,基于图像处理技术定量分析了气泡碰撞形变、黏附时间、三相接触线扩散特性及其影响因素。结果表明:变形因子随气泡直径的增大由略大于1.00逐渐演化为略小于1.00,疏水性强的塑料平板使相同直径气泡的变形因子更大,碰撞时间随气泡直径的增大而增加,随疏水性的增加而减小。塑料平板疏水性越强,形成三相接触所用时间越短,当气泡直径为1.0 mm时,聚四氟乙烯(PTFE)和聚甲基丙烯酸甲酯(PMMA)平板的液膜排液时间均出现极小值,分别为4.8 ms和56 ms。三相接触线扩散时间随气泡直径的增大而增大,随塑料平板疏水性的增大而减小,在气泡直径大小相同时,三相接触线扩散直径随塑料平板疏水性的减小而减小。
Abstract:In order to reveal the influence of bubble size and surface hydrophobicity on the flotation process of plastics, high-speed photography was used to observe the collision and adhesion behavior of rising bubbles and plastic plates in pure water medium. According to the change of bubble velocity, it is divided into three stages:collision, liquid film drainage and three-phase contact line diffusion. Based on image processing technology, the bubble collision deformation, adhesion time, three-phase contact line diffusion characteristics and their effects are quantitatively analyzed. The results show that the deformation factor gradually evolves from slightly larger than 1.00 to slightly less than 1.00 as the diameter of the bubble increases. The hydrophobic plate with strong hydrophobicity makes the deformation factor of the same diameter bubble larger, and the collision time increases with the increase of the bubble diameter, but decreases with the increase of the hydrophobicity. The stronger the hydrophobicity of the plastic plate is, the shorter the time it takes to form a three-phase contact. When the bubble diameter is 1.0mm, the liquid film discharge time of both the poly tetra fluoroethylene (PTFE) and polymethyl methacrylate (PMMA) plates is extremely small, which are 4.8 ms and 56 ms respectively. The diffusion time of the three-phase contact line increases with the increase of the bubble size, and decreases with the increase of the hydrophobicity of the plate. When the bubble size is the same, the diffusion diameter of the three-phase contact line decreases as the hydrophobicity of the plate decreases.
-
Key words:
- plastic flotation /
- bubble /
- hydrophobicity /
- collision /
- attachment
-
-
[1] 孙安垣, 闫烨, 杨超, 等.我国改性塑料行业的发展前景[J].工程塑料应用, 2011, 39(2):83-87. doi: 10.3969/j.issn.1001-3539.2011.02.022SUN A H, YAN Y, YANG C, et al.Development prospect of modified plastics in China[J]. Engineering Plastics Application, 2011, 39(2):83-87(in Chinese). doi: 10.3969/j.issn.1001-3539.2011.02.022 [2] 沈军, 谢怀勤.先进复合材料在航空航天领域的研发与应用[J].材料科学与工艺, 2008, 16(5):737-740. doi: 10.3969/j.issn.1005-0299.2008.05.036SHEN J, XIE H Q.Development of research and application of the advanced composite materials in the aerospace engineering[J]. Materials Science and Technology, 2008, 16(5):737-740(in Chinese). doi: 10.3969/j.issn.1005-0299.2008.05.036 [3] 卢子兴, 张慧.聚碳酸酯微孔塑料的动态力学热分析[J].北京航空航天大学学报, 2006, 32(9):1109-1112. doi: 10.3969/j.issn.1001-5965.2006.09.026LU Z X, ZHANG H.Thermal analysis for dynamic behavior of microcellular polycarbonate[J]. Journal of Beijing University of Aeronautics and Astronautics, 2006, 32(9):1109-1112(in Chinese). doi: 10.3969/j.issn.1001-5965.2006.09.026 [4] 王金锋, 郑晓泉, 李盛涛, 等.典型空间聚合物介质的抗内带电改性技术[J].北京航空航天大学学报, 2011, 37(2):180-184. https://bhxb.buaa.edu.cn/CN/abstract/abstract11887.shtmlWANG J F, ZHENG X Q, LI S T, et al.Internal charging protection technology of typical space polymer dielectric material[J]. Journal of Beijing University of Aeronautics and Astronautics, 2011, 37(2):180-184(in Chinese). https://bhxb.buaa.edu.cn/CN/abstract/abstract11887.shtml [5] 曹飞龙, 李焕喜, 沈志刚.飞灰空心微珠/聚丙烯复合材料的弹性模量预测[J].北京航空航天大学学报, 2005, 31(6):87-90. https://bhxb.buaa.edu.cn/CN/abstract/abstract10316.shtmlCAO F L, LI H X, SHEN Z G.Modulus prediction of a polymer matrix composite reinforced with fly-ash hollow microspheres[J]. Journal of Beijing University of Aeronautics and Astronautics, 2005, 31(6):87-90(in Chinese). https://bhxb.buaa.edu.cn/CN/abstract/abstract10316.shtml [6] 陈丹, 黄兴元, 汪朋, 等.废旧塑料回收利用的有效途径[J].工程塑料应用, 2012, 40(9):92-94. doi: 10.3969/j.issn.1001-3539.2012.09.023CHEN D, HUANG X Y, WANG P, et al.Recycling effective ways of waste plastics[J]. Engineering Plastics Application, 2012, 40(9):92-94(in Chinese). doi: 10.3969/j.issn.1001-3539.2012.09.023 [7] 周炳炎, 郭琳琳, 李丽, 等.我国塑料包装废物的产生和回收特性及管理对策[J].环境科学研究, 2010, 23(3):282-287. http://d.old.wanfangdata.com.cn/Periodical/hjkxyj201003007ZHOU B Y, GUO L L, LI L, et al.Characteristics of generation and recycling of plastic packaging waste in China and management countermeasures[J]. Research of Environmental Sciences, 2010, 23(3):282-287(in Chinese). http://d.old.wanfangdata.com.cn/Periodical/hjkxyj201003007 [8] WANG C, WANG H, FU J, et al.Flotation separation of waste plastics for recycling-A review[J]. Waste Management, 2015, 41:28-38. doi: 10.1016/j.wasman.2015.03.027 [9] NIECIKOWSKA A, ZAWALA J, MILLER R, et al.Dynamic adsorption layer formation and time of bubble attachment to a mica surface in solutions of cationic surfactants[J]. Colloids and Surfaces A:Physicochemical and Engineering Aspects, 2010, 365(1):14-20. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=5d966517b38372d7b2721fa058683ed0 [10] KRASOWSKA M, ZAWALA J, MALYSA K.Air at hydrophobic surfaces and kinetics of three phase contact formation[J]. Advances in Colloid and Interface Science, 2009, 147-148:155-169. doi: 10.1016/j.cis.2008.10.003 [11] KRASOWSKA M, MALYSA K.Wetting films in attachment of the colliding bubble[J]. Advances in Colloid and Interface Science, 2007, 134(21):138-150. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=8c2782553bc0528713a6eb754d80130a [12] KRASOWSKA M, MALYSA K.Kinetics of bubble collision and attachment to hydrophobic solids:Ⅰ.Effect of surface roughness[J]. International Journal of Mineral Processing, 2007, 81(4):205-216. doi: 10.1016/j.minpro.2006.05.003 [13] HOEK E M, AGARWAL G K.Extended DLVO interactions between spherical particles and rough surfaces[J]. Journal of Colloid and Interface Science, 2006, 298(1):50-58. doi: 10.1016/j.jcis.2005.12.031 [14] KOWALCZUK P B, ZAWALA J.A relationship between time of three-phase contact formation and flotation kinetics of naturally hydrophobic solids[J]. Colloids and Surfaces A:Physicochemical and Engineering Aspects, 2016, 506:371-377. doi: 10.1016/j.colsurfa.2016.07.005 [15] 傅慧萍, 李杰.微气泡减阻的数值模拟方法及尺寸效应[J].上海交通大学学报, 2016, 50(2):278-282. doi: 10.3969/j.issn.1674-8115.2016.02.025FU H P, LI J.Numerical simulation methods of micro-bubbles drag reduction and scale effect[J]. Journal of Shanghai Jiaotong University, 2016, 50(2):278-282(in Chinese). doi: 10.3969/j.issn.1674-8115.2016.02.025 [16] SUBASINGHE G K N, ALBIJANIC B.Influence of the propagation of three phase contact line on flotation recovery[J]. Minerals Engineering, 2014, 57:43-49. doi: 10.1016/j.mineng.2013.12.008