A transient modeling method for unknown information regulating valves in complex pipeline network system
-
摘要:
关键调节阀信息缺失是制约复杂管网系统可建模的重要因素。通过对调节阀建模研究的分类和总结,得出了多数调节阀的流量特性曲线均处于等百分比与线性之间的结论;进而针对结构和节流特性均未知的调节阀,提出了一种利用信息已知的基准阀门模型和有限的系统试验数据进行建模的方法。对核心机试验台气路系统中2个未知信息调节阀的建模与仿真表明:在常温0~1 400 s、低温0~1 240 s两种工况下,选用3种不同基准阀门模型仿真结果的差别低于10%,2个调节阀在47组件气路全系统仿真中的流量曲线与试验曲线之间的平均误差在15%以内,系统下游两支路的压强仿真曲线与试验曲线之间的最大误差低于15%,为解决此类问题提供了一种有效的建模方案。
Abstract:The information missing of key regulating valve is an important factor to restrict the modeling of complex pipeline network systems. After classifying and summarizing the modeling research of regulating valves, the conclusion that the flow characteristic curves of most regulating valves are between the equal percentage and the linearity is obtained. Based on this conclusion, a modeling method by using the information-known reference-valve model and the limited system test data is proposed for the valves whose structure and throttling characteristics are unknown. Then, this method is used to establish the models of two unknown-information valves in the core engine test rig gas circuit system. The application to two working conditions including 0-1 400 s normal-temperature condition and 0-1 240 s low-temperature condition shows that the differences of the simulation curves among three different reference-valve models are less than 10%; the average errors between the flow-rate simulation curves of two regulating valves in the 47-component system and the test curves are within 15%; the maximum errors between the pressure simulation curves and the test curves at two downstream branches are within 15%. Thus, the proposed method can provide an effective modeling scheme to solve this kind of problem.
-
表 1 使用标定-校准方法计算的F3调节阀额定流量系数
Table 1. Calculation process of F3 valve rated flow coefficient by calibration-adjusting method
基准阀门模型 系统试验数据 额定流量系数标定结果 额定流量系数校准结果 p1/MPa p2/MPa T1/K T2/K τ Qm/(kg·s-1) Vanessa阀
HCB阀
YYL阀1.37 超临界情况下不需要 289.86 超临界情况下不需要 0.44 14.67 60.24(KvRating)
351.4 (CdRating)
741.6(CdRating)81.64(KvRating)
410(CdRating)
960(CdRating)表 2 使用试算-标定方法计算的F4调节阀额定流量系数
Table 2. Calculation process of F4 valve rated flow coefficient by trial-calibration method
基准阀门模型 二分法 试算次数 额定流量系数标定结果 额定流量系数最终收敛区间 最小初值 最大初值 Vanessa阀 1.0 81.64 10 4.5(KvRating) (4.78, 5.10) HCB阀 1.0 81.64 7 39(CdRating) (38.8, 41.32) YYL阀 1.0 200 7 63(CdRating) (61.63, 63.19) -
[1] 张宏伟, 王晨婉, 牛志广, 等.城市供水管网物理模型构建方法[J].天津大学学报, 2008, 41(7):859-863. doi: 10.3969/j.issn.0493-2137.2008.07.018ZHANG H W, WANG C W, NIU Z G, et al.Constructing method for the physical model of municipal water distribution system[J].Journal of Tianjin University, 2008, 41(7):859-863(in Chinese). doi: 10.3969/j.issn.0493-2137.2008.07.018 [2] GEORGESCU S C, GEORGESCU A M, JUMARA A, et al.Numerical simulation of the cooling water system of a 115 MW hydro-power plant[J].Energy Procedia, 2016, 85:228-234. doi: 10.1016/j.egypro.2015.12.230 [3] GOREV N B, KODZHESPIROVA I F, SIVAKUMAR P.Modeling of flow control valves with a nonzero loss coefficient[J].Journal of Hydraulic Engineering, 2016, 142(11):1-3. [4] 杨毅, 周志斌, 李长俊, 等.天然气管输调节控制仿真模型[J].天然气工业, 2008, 28(10):98-100. doi: 10.3787/j.issn.1000-0976.2008.10.031YANG Y, ZHOU Z B, LI C J, et al.Research on natural gas pipeline regulation control simulation model[J].Natural Gas Industry, 2008, 28(10):98-100(in Chinese). doi: 10.3787/j.issn.1000-0976.2008.10.031 [5] ZHANG L.Simulation of the transient flow in a natural gas compression system using a high-order upwind scheme considering the real-gas behaviors[J].Journal of Natural Gas Science and Engineering, 2016, 28:479-490. doi: 10.1016/j.jngse.2015.12.012 [6] LI C J, JIA W L, WU X.A steady state simulation method for natural gas pressure-relieving systems[J].Journal of Natural Gas Science and Engineering, 2014, 19:1-12. doi: 10.1016/j.jngse.2014.04.012 [7] MAHGEREFTEH H, SUNDARA V, BROWN S, et al.Modelling emergency isolation of carbon dioxide pipelines[J].International Journal of Greenhouse Gas Control, 2016, 44:88-93. doi: 10.1016/j.ijggc.2015.11.001 [8] 陈勇, 李隆键, 程静.液氧输送管路中阀控瞬变的数值计算[J].哈尔滨工业大学学报, 2013, 45(9):75-81. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hebgydxxb201309014CHEN Y, LI L J, CHENG J.Numerical computation of hydraulic transients in valve operating processes of LO2 delivery pipes[J].Journal of Harbin Institute of Technology, 2013, 45(9):75-81(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hebgydxxb201309014 [9] CHEN Y, CAI G B, WU Z.Modularization modeling and simulation of turbine test rig main test system[J].Applied Mathematical Modelling, 2011, 35(11):5382-5399. doi: 10.1016/j.apm.2011.04.041 [10] CHEN Y, CAI G B, ZHANG Z P, et al.Multi-field coupling dynamic modeling and simulation of turbine test rig gas system[J].Simulation Modelling Practice and Theory, 2014, 44:95-118. doi: 10.1016/j.simpat.2014.03.004 [11] 史智俊, 张国磊, 李彦军, 等.回汽保护控制下舰用蒸汽动力系统响应规律[J].化工学报, 2015, 66(S2):287-293. doi: 10.11949/j.issn.0438-1157.20150649SHI Z J, ZHANG G L, LI Y J, et al.Response pattern of marine steam power system under back-steam protection[J].CIESC Journal, 2015, 66(S2):287-293(in Chinese). doi: 10.11949/j.issn.0438-1157.20150649 [12] 裴希同, 张松, 但志宏, 等.高空台飞行环境模拟系统数字建模与仿真研究[J].推进技术, 2019, 40(1):332-340. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=tjjs201905022PEI X T, ZHANG S, DAN Z H, et al.Study on digital modeling and simulation of altitude test facility flight environment simulation system[J].Journal of Propulsion Technology, 2019, 40(1):332-340(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=tjjs201905022 [13] 孟成, 苏明.重型燃气轮机天然气供应系统整体性能仿真[J].上海交通大学学报, 2016, 50(4):483-489. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=shjtdxxb201604001MENG C, SU M.Performance simulation of natural gas supply system of a heavy duty gas turbine[J].Journal of Shanghai Jiaotong University, 2016, 50(4):483-489(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=shjtdxxb201604001 [14] PILLER O, VANZYL J E.Modeling control valves in water distribution systems using a continuous state formulation[J]. Journal of Hydraulic Engineering, 2014, 140(11):1-9. [15] CHEN Y, WANG H S, XIA J X, et al.Dynamic modeling and simulation of an integral bipropellant propulsion double-valve combined test system[J].Acta Astronautica, 2017, 133:346-374. doi: 10.1016/j.actaastro.2016.10.010 [16] 何衍庆, 邱宣振, 杨洁, 等.控制阀工程设计与应用[M].北京:化学工业出版社, 2005:46-49.HE Y Q, QIU X Z, YANG J, et al.Control valves engineering design and application[M].Beijing:Chemical Industry Press, 2005:46-49(in Chinese). [17] 胡继敏, 金家善, 严志腾.储汽筒充汽系统的热力过程建模与仿真[J].上海交通大学学报, 2012, 46(4):545-549. http://www.cnki.com.cn/Article/CJFDTotal-SHJT201204008.htmHU J M, JIN J S, YAN Z T.Modeling and simulation for thermodynamic process of steam accumulato system[J].Journal of Shanghai Jiaotong University, 2012, 46(4):545-549(in Chinese). http://www.cnki.com.cn/Article/CJFDTotal-SHJT201204008.htm [18] 李亦健, 高旭, 陈虹, 等.低温推进剂加注系统置换介质的相似性分析[J].推进技术, 2018, 39(3):703-708. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=tjjs201803026LI Y J, GAO X, CHEN H, et al.Similarity analysis of different replacement gases for cryogenic propellant loading system[J].Journal of Propulsion Technology, 2018, 39(3):703-708(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=tjjs201803026 [19] 李树勋, 李忠, 周爱民, 等.三通调节球阀节流盘开口型线优化及试验研究[J].华中科技大学学报(自然科学版), 2017, 45(2):61-66. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hzlgdxxb201702012LI S X, LI Z, ZHOU A M, et al.Optimization and test on throttle plate opening profile line of 3-way control ball valve[J].Journal of Huazhong University of Science and Technology(Natural Science Edition), 2017, 45(2):61-66(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hzlgdxxb201702012 [20] 白雪莲, 吴静怡.管网系统中平衡阀对调节阀调节作用的影响[J].上海交通大学学报, 2006, 40(2):364-368. doi: 10.3321/j.issn:1006-2467.2006.02.041BAI X L, WU J Y.The influence of balance valve on action of regulating valve in pipe network[J].Journal of Shanghai Jiaotong University, 2006, 40(2):364-368(in Chinese). doi: 10.3321/j.issn:1006-2467.2006.02.041 [21] 陈阳, 高芳, 张振鹏, 等.准一维可压缩瞬变管流的有限体积模型(Ⅱ)管壁温度场的有限体积模型[J].航空动力学报, 2008, 23(2):317-322. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkdlxb200802020CHEN Y, GAO F, ZHANG Z P, et al.Finite volume model for quasi one-dimensional compressible transient pipe flow(Ⅱ)Finite volume model of temperature field[J].Journal of Aerospace Power, 2008, 23(2):317-322(in Chinese). http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkdlxb200802020 [22] LIANG Y Y, WANG D D, CHEN J P, et al.Temperature control for a vehicle climate chamber using chilled water system[J].Applied Thermal Engineering, 2016, 106:117-124. doi: 10.1016/j.applthermaleng.2016.05.168