北京航空航天大学学报 ›› 2006, Vol. 32 ›› Issue (07): 847-851.

• 论文 • 上一篇    下一篇

变截面毛细通道中气泡的运动特性分析

曹瑜, 张佐光, 赵卫娟   

  1. 北京航空航天大学 材料科学与工程学院, 北京 100083
  • 收稿日期:2005-08-18 出版日期:2006-07-31 发布日期:2010-09-19
  • 作者简介:曹 瑜(1981-), 男, 江西都昌人, 硕士生, i cy@msn.com.
  • 基金资助:

    国家973资助项目(2003CB615602) ; 国家863资助项目(2001AA335020)

Mobility behavior for driving bubble traversing constricted capillary tubes

Cao Yu, Zhang Zuoguang, Zhao Weijuan   

  1. School of Materials Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100083, China
  • Received:2005-08-18 Online:2006-07-31 Published:2010-09-19

摘要: 为了确定复合材料成型过程中气泡的运动条件,利用变截面毛细模拟通道实验系统,研究了气泡在变截面毛细管中的运动行为,分析了气泡长度、毛细管半径及液体种类对气泡垂直穿出行为的影响,并从理论角度推导出气泡穿出的临界压力方程.研究结果表明,气泡垂直穿出变截面毛细通道所需要的临界压力差,随气泡长度和毛细管半径的增大而减小,液体种类对其也有明显影响,实验结果与理论计算值基本吻合.该研究结果将为复合材料成型中工艺参数的优化提供实验依据.

Abstract: Constricted capillary tubes were used in order to study bubble mobility condition in composite material during cure processing. The effects of bubble length, radius of capillary tube and the variety of liquid on the drive critical condition of a single bubble traversing through a joint of flow channel of constricted capillary tubes were studied. The results demonstrate that the critical pressure difference of bubble traversing through joint of constricted capillary tubes perpendicularly decreases with the increase of bubble length or the radius of capillary tube, and is also affected by the variety of liquid obviously. The experimental result tallies with the theoretical results, and the study has a certain reference value to optimize cure processing to reduce and remove voids in composites.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发