Effects of cylindrical hole accompanied with anti-vortex holes on film cooling effectiveness
-
摘要: 采用数值模拟方法研究了大小气膜孔交替排列(均匀排列的圆柱形单孔两侧分别开设一个平行的小孔)情况下的流动和换热,并与常规的圆柱形单孔结构进行对比,分析大小气膜孔交替排列提高冷效的机理,研究大小孔的孔径比对气膜冷却效果的影响规律.结果发现:在圆柱形单孔两侧分别设置一个平行的辅助小孔,大小孔冷气射流的肾形涡相互干涉,导致主气膜孔下游的肾形涡的尺度和强度与圆柱形单孔相比均有明显降低,气膜冷却效果明显改善.相同冷气量下,小孔孔径越大,分配的冷气流量越大,对主孔冷气射流的干涉作用越强,气膜冷却效果改善越明显;当小孔孔径d2=4mm时,气膜冷却结构类似常规的离散圆柱形气膜孔,气膜冷却效果开始下降.Abstract: The primary focus was to further understand the flow and heat transfer aspects of a special film cooling hole arrangement where the main film cooling hole was accompanied by two parallel anti-vortex jet holes. The cooling effectiveness and the interaction between the main hot stream and the coolant jets were simulated and compared with the standard single hole arrangement. It is found that the presence of anti-vortex jets decreased the size and the strength of the counter-rotating vortex pair of the main coolant jet and so is its mixing with the main hot stream. The surface film effectiveness value is improved as expected. A bigger diameter of anti-vortex holes means more obvious improvement of film cooling.
-
Key words:
- film cooling /
- adiabatic effectiveness /
- jet /
- counter-rotating vortex pair
-
[1] 韩介勤，桑地普·杜达，斯瑞纳斯·艾卡德.燃气轮机传热和冷却技术[M].西安:西安交通大学出版社，2005：87-163 Han J Q，Dutta S，Ekkad S V.Gas turbine heat transfer and cooling technology[M].Xi'an：Xi'an Jiaotong University Press，2005：87-163 (in Chinese) [2] Dhungel A，Lu Y P，Phillips W，et al.Film cooling from a row of holes supplemented with anti-vortex holes[R].ASME Paper GT2007-27419，2007 [2] Heidmann J D，Ekkad S V.A novel anti-vortex turbine filmcooling hole concept[R].ASME Paper GT2007-27528，2007 [4] Silieti M，Kassab A J，Divo E.Film cooling effectiveness：comparison of adiabatic and conjugate heat transfer CFD models[J].International Journal of Thermal Sciences，2009,48(12)：2237-2248 [5] Schmidt D L，Sen B，Bogard D G.Film cooling with compound angle holes：adiabatic effectiveness[J].Journal of Turbomachinery，1996,118(4)：807-813 [6] Sinha A，Bogard D G，Crawford M.Film cooling effectiveness downstream of a single row of holes with variable density ratio[J].Journal of Turbomachinery，1991,113(3)：442-449 [7] 张燕．横流冲击射流漩涡结构的实验和数值研究[D].上海：上海大学，上海市应用数学和力学研究所，2005 Zhang Yan.Experimental and numerical investigations on the vertical structures of an impinging jet in crossflow[D].Shanghai：Shanghai Institute of Applied Mathematics，Shanghai University and Mechanics，2005(in Chinese) -
点击查看大图
计量
- 文章访问数: 3292
- HTML全文浏览量: 157
- PDF下载量: 1360
- 被引次数: 0
下载:
