北京航空航天大学学报 ›› 1998, Vol. 24 ›› Issue (3): 323-326.

• 论文 • 上一篇    下一篇

基于STEP/AP203的CAD几何平台设计方法研究

任爱华, 魏菊霞   

  1. 北京航空航天大学 计算机科学与工程系
  • 收稿日期:1997-03-17 出版日期:1998-03-31 发布日期:2010-09-29
  • 作者简介:女 40岁 副教授 100083 北京
  • 基金资助:

    863高技术计划(8635119503001)资助项目

Research on Design Principles to CAD/CAM Geometric Platform Based on STEP/AP203

Ren Aihua, Wei Juxia   

  1. Beijing University of Aeronautics and Astronautics,Dept. of Computer Science and Engineering
  • Received:1997-03-17 Online:1998-03-31 Published:2010-09-29

摘要: 介绍在STEP/AP203标准语义模型共享为基础的CAD/CAM系统集成中,一般几何表示的设计原理与方法.STEP标准提供了以面向对象为基础的软组件结构实现的可能,因而,扩大了CAD/CAM集成系统在面向需求变化中的开放性.文中给出了一般框架, 允许采用不同的图形包几何表达AP203语义模型.

Abstract: The approaches and the design principles to the CAD/CAM geometric platform based on shared standard semantic models of STEP/AP203 in the CIMS environment are expounded in this paper. STEP gives the possibility of developing software component architecture in terms of object-oriented technology. Therefore, the more flexible and open properties can be provided by the CAD/CAM integrated system to meet requirement oriented changes. These properties are the key elements to support the future integrated manufacturing business and concurrent engineering ect.. A general purpose geometric platform frame which is independent of specific graphics systems is given in this paper. The frame is fit for different kinds of specific graphics systems. The advantage for the approaches shows that the software design of CAD/CAM is independent from specific graphics systems. Within the scope of some powerful graphics system, the CAD software can be run on these graphics systems by plugging the systems' APIs in the correspondent API (Applicatin Programme Interface) sockets.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发