Method for EMC antenna factor temperature error correction
-
摘要: 为减小外场环境温度的影响,提高电磁兼容性(EMC)测试设备的测量精度,提出了一种电磁兼容测量天线系数温度误差修正方法.首先,根据1m距离两天线校准原理,理论推导了近场情况下采用透波材料制作的温控装置对接收天线接收特性的影响,结合仿真分析与试验结果,验证了使用温控装置带来的测试误差可控制在允许的范围内.然后,在此基础上,通过实际测试获得了典型天线的天线系数随温度的变化规律及误差修正曲面.最后,采用对比标准条件下和开阔试验场条件下的测试结果的方法来验证该方法的有效性.结果表明,在保证测量精度的前提下,通过天线系数温度误差修正,可将天线的使用环境温度扩展到-40~+50℃,进而减小外场试验测试误差.适用于双锥、对数周期和双脊喇叭等天线的天线系数温度误差修正.
-
关键词:
- 电磁兼容性(EMC) /
- 天线系数 /
- 温度 /
- 修正 /
- 校准
Abstract: In order to reduce the influence of the outfield environmental temperature and improve the measuring precision of electromagnetic compatibility(EMC) test equipment, a method for antenna factor temperature error correction was presented. Firstly, according to the principle of two antenna calibration with 1m distance, the antenna receiving characteristic influenced by temperature control device made by radome material under the condition of near field was theoretically deduced. Combined with the simulation analysis and test results proved that the test error can be controlled in the permitted range by using the temperature control device. Secondly, on this basis the antenna factor variation with temperature and temperature error correction surface for typical antenna was obtainedby the actual test. In the end, the method was verified by comparing the test result uder standard conditions with the test result under the open area test site (OATS) condition. The results prove that this method can expand the environmental temperature range of use from -40℃ to 50℃ by antenna factor temperature error correction on the premise of not reducing measurement precision, and suitable for the antenna factor temperature error correction in EMC double cone antenna and log periodic antenna and the double ridged horn antenna, etc.-
Key words:
- electromagnetic compatibility (EMC) /
- antenna factor /
- temperature /
- correction /
- calibration
-
[1] GJB/1389A-2005.系统电磁兼容性要求[S].北京:中国人民解放军总装备部,2005:2-13.GJB/1389A-2005.Electromagnetic compatibility requirements for systems[S].Beijing:PLA General Armament Department,2005:2-13(in Chinese). [2] GJB/151B-2013.军用设备和分系统电磁发射和敏感度要求与测量[S].北京:国防科学技术工业委员会,2013:2-8.GJB/151B-2013.Requirements and measurement of electromagnetic emission and susceptibility for military equipment and subsystems[S].Beijing:Commission of Science,Technology and Industry for National Defense of the PRC,2013:2-8(in Chinese). [3] 苏东林,戴飞,谢树果,等.天线系数的测试误差与NSA测试的改进[J].北京航空航天大学学报,2007,33(11):1291-1294.Su D L,Dai F,Xie S G,et al.Errors of antenna factor and improved method for NSA test[J].Journal of Beijing University of Aeronautics and Astronautics,2007,33(11):1291-1294(in Chinese). [4] 沈国连.EMC测试中天线系数的误差分析[J].航空电子技术,2001,32(2):1-5.Shen G L.Error analysis of antenna factor for EMC test[J].Chinese Avionics Technology,2001,32(2):1-5(in Chinese). [5] CISPR16-1-6-2008.Standard for the calibration of antennas used for radiated emission measurements[S].Geneva:International Electrotechnical Commission,2008:2-5. [6] ANSI C63.5-2004.American national standard for electromagnetic compatibility-radiated emission measurements in electromagnetic interference (EMI) control-calibration of antennas (9kHz to 40GHz)[S].New York:Institute of Electrical and Electronic Engineers,Inc,2004:3-16. [7] Garn H,Buchmayr M,Mullner W,et al.Primary standards for antenna factor calibration in the frequency range of (30 to 1000) MHz[J].IEEE Transactions on Instrumentation & Measurement,1997,46(2):544-558. [8] Meng D L,Alexander M J.Calibration of biconical antennas by vertically stacking method[J].IEEE Transactions on Electromagnetic Compatibility,2014,56(6):1262-1270. [9] Das S K,Rao P H,Kanda M.Calibration of antenna factor of a tuned dipole using two antenna method,NIST method and a proposed reference antenna[C]∥Proceedings of International Conference on Electromagnetic Interference & Compatibility.Piscataway,NJ:IEEE Press,1995:263-265. [10] Jeong H K,Jeong I P,Ung T K,et al.Antenna factor calibration in 30-1000MHz frequency range[C]∥Proceedings of Conference on Precision Electromagnetic Measurements Digest.Piscataway,NJ:IEEE Press,1996:423-424. [11] de marinis J.Quality control of antenna calibration and site-attenuation data from open area test sites[C]∥Proceedings of IEEE International Symposium on Electromagnetic Compatibility,Symposium Record.Piscataway,NJ:IEEE Press,1988:290-294. [12] Morioka T,Hirasawa K.Proper antenna factors for the normalized site attenuation above a ground plane[J].IEEE Transactions on Electromagnetic Compatibility,2013,56(2):246-258. [13] Chen Y M,Chen H Y,Ting Y T,et al.Calibration of antenna factor in nonstandard environments[C]∥Proceedings of Asia-Pacific Microwave Conference.Piscataway,NJ:IEEE Press,2001,3:1318-1321. [14] Liu X X,Ma W Y,Zhang T.The research about the double ridge horn calibration in local EMC testing chambers measurements and uncertainty evaluations[C]∥Proceedings of IEEE 5th International Symposium on Microwave,Antenna,Propagation and EMC Technologies for Wireless Communications.Piscataway,NJ:IEEE Press,2013:311-314. [15] Hong T,Chou C L,Kuo A.Improving calibration of broadband antenna factors in a GTEM cell[C]∥Proceedings of International Symposium on Electromagnetic Compatibility.Piscataway,NJ:IEEE Press,1999:592-595. [16] GJB/J5410-2005.电磁兼容测量天线的天线系数校准规范[S].北京:国防科学技术工业委员会,2005:5-6.GJB/J5410-2005.Antenna factor calibration standard of EMC measurement antenna[S].Beijing:Commission of Science,Technology and Industry for National Defense of the PRC,2005:5-6(in Chinese). [17] 张敏.CST微波工作室®用户全书[M].成都:电子科技大学出版社,2014:50-210.Zhang M.CST Microwave studio® user encyclopedia[M].Chengdou:University of Electronic Science and Technology of China Press,2014:50-210 (in Chinese).
点击查看大图
计量
- 文章访问数: 1059
- HTML全文浏览量: 145
- PDF下载量: 654
- 被引次数: 0