基于母线电流的无刷直流电机换相位置优化策略

张前; 冯明

doi:10.13700/j.bh.1001-5965.2015.0429

基于母线电流的无刷直流电机换相位置优化策略

doi: 10.13700/j.bh.1001-5965.2015.0429

张前,
冯明^,

北京科技大学机械工程学院, 北京 100083

基金项目: 国家“863”计划（SS2012AA110501）

详细信息

作者简介:
张前男,博士研究生。主要研究方向:无刷直流电机及永磁同步电机控制系统。Tel.: 18600003063 E-mail: jz_ustb@163.com;冯明男,博士,教授,博士生导师。主要研究方向:高速电机设计及其控制。Tel.: 010-82376928 E-mail: mingfeng@me.ustb.edu.cn

通讯作者:
冯明,Tel.: 010-82376928 E-mail: mingfeng@me.ustb.edu.cn

中图分类号: TM301.2
计量
- 文章访问数: 1408
- HTML全文浏览量: 87
- PDF下载量: 892
- 被引次数: 0
出版历程
- 收稿日期: 2015-06-26
- 网络出版日期: 2016-07-20

BLDC motor commutation position optimization strategy based on bus current

ZHANG Qian,
FENG Ming^,

School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China

摘要

摘要: 通过分析无刷直流（BLDC）电机换相位置与母线电流的关系，建立了母线电流与换相位置偏差的数学关系，在此基础上提出了一种无位置传感器无刷直流电机换相位置优化策略。该策略以控制绕组电流与反电动势（BEMF）同相位为目标，以换相位置补偿角为被控制量，以母线电流随换相角度的变化率作为偏差量，通过比例积分（PI）调节器调节电机换相位置;并且可以同时校正位置信号检测误差和绕组电感引起的相位偏差。通过实验验证了该策略可以准确、快速地找到最佳换相位置，有效提高电机运行效率。
- 无刷直流(BLDC)电机 /
- 无位置传感器 /
- 母线电流 /
- 换相位置优化 /
- 反电动势(BEMF)法
Abstract: This paper analyzes the relation between commutation position of brushless direct current (BLDC) motors and bus current, builds up their mathematical relation, and proposes a sensorless BLDC motors commutation position optimization strategy. This strategy regulates the commutation position by a proportional integral (PI) adjuster, aiming at regulating the current and the back electromotive force (BEMF) in-phase. The controlled variable of the PI adjuster is the commutation position compensating angle and the deviation value is the ratio of current change over angle. This optimization strategy can revise the detected position signal error and the phase deviation caused by the winding inductance at the same time. The experimental results verify that this optimization strategy can get the best commutation position accurately and fast, and improve the operating efficiency effectively.
- brushless direct current (BLDC) motor /
- sensorless /
- bus current /
- commutation position optimization /
- back electromotive force (BEMF) method

HTML全文

参考文献(16)

[1]	ACARNLEY P P,WATSON J F.Review of position-sensorless operation of brushless permanent-magnet machines[J].IEEE Transactions on Industrial Electronics,2006,53(2):352-362.
[2]	DAMODHARAN P,VASUDEVAN K.Sensorless brushless DC motor drive based on the zero-crossing detection of back electromotive force(EMF) from the line voltage difference[J].IEEE Transactions on Energy Conversion,2010,25(3):661-668.
[3]	BI C,HLA N P,JIANG Q,et al.Back-EMF ZCP error induced by electromagnetic structure of spindle motor[J].IEEE Transactions on Magnetics,2011,47(7):1899-1905.
[4]	ZWYSSIG C,KOLAR J W,ROUND S D. Megaspeed drive systems:Pushing beyond 1 million r/min[J].IEEE/ASME Transactions on Mechatronics,2009,14(5):564-574.
[5]	OGASAWARA S,AKAGI H. An approach to position sensorless drive for brushless DC motors[J].IEEE Transactions on Industry Applications,1991,27(5):928-933.
[6]	ERTUGRUL N,ACARNLEY P.A new algorithm for sensorless operation of permanent magnet motors[J].IEEE Transactions on Industry Applications,1994,30(1):126-133.
[7]	FAKHAM H,DJEMAI M,BUSAWON K.Design and practical implementation of a back-EMF sliding-mode observer for a brushless DC motor[J].IET Electric Power Applications,2008,2(6):353-361.
[8]	KASA N,WATANABE H.A mechanical sensorless control system for salient-pole brushless DC motor with autocalibration of estimated position angles[J].IEEE Transactions on Power Electronics,2000,47(2):389-395.
[9]	宋飞,周波,吴小婧.校正无位置传感器无刷直流电机位置信号相位的闭环控制策略[J].中国电机工程学报,2009,29(12):52-57.SONG F,ZHOU B,WU X J.Closed loop control method to correct position phase for sensorless brushless DC motor[J].Proceedings of the CSEE,2009,29(12):52-57(in Chinese).
[10]	吴小婧,周波,宋飞.基于端电压对称的无位置传感器无刷直流电机位置信号相位校正[J].电工技术学报,2009,24(4):54-60.WU X J,ZHOU B,SONG F.A new control method to correct position phase for sensorless brushless DC motor[J].Transactions of China Electrotechnical Society,2009,24(4):54-60(in Chinese).
[11]	韦鲲,任军军,张仲超.三次谐波检测无刷直流电机转子位置的研究[J].中国电机工程学报,2004,24(5):163-167.WEI K,REN J J,ZHANG Z C. Research on the scheme of sensing rotor position of BLDCM based on the third harmonic component[J].Proceedings of the CSEE,2004,24(5):163-167(in Chinese).
[12]	LIN M Y,LI Q,GU W G.Effect of rotor position error on commutation in sensorless BLDC motor drives[C]//8th International Conference on Electrical Machines and Systems(ICEMS 2005).Piscataway, NJ:IEEE Press,2005.
[13]	SAMOYLENKO N,HAN Q,JATSKEVICH J.Balancing hall-effect signals in low-precision brushless DC motors[C]//Applied Power Electronics Conference(APEC 2007).Piscataway,NJ:IEEE Press,2007.
[14]	JIANG Q,BI C,HUANG R Y.A new phase-delay-free method to detect back EMF zero-crossing points for sensorless control of spindle motros[J].IEEE Transactions on Magnetics,2005,41(7):2287-2294.
[15]	SHEN J X,TSENG K J.Analysis and compensation of rotor position detection error in sensorless PM brushelss DC motor drives[J].IEEE Transactions on Energy Conversion,2003,18(1):87-93．
[16]	HAN Q,SAMOYLENKO N, JATSKEVICH J.Average-value modeling of brushless DC motors with 120° voltage source inverter[J].IEEE Transactions on Energy Conversion,2008,23(2):423-432.