冲击位置对斜搭接接头冲击后拉伸性能的影响

聂恒昌; 徐吉峰; 关志东; 黎增山; 冀赵杰; 谭日明

doi:10.13700/j.bh.1001-5965.2015.0694

冲击位置对斜搭接接头冲击后拉伸性能的影响

doi: 10.13700/j.bh.1001-5965.2015.0694

1.
北京航空航天大学航空科学与工程学院, 北京 100083
2. 中国商飞北京民用飞机技术研究中心, 北京 102211

详细信息

作者简介:
聂恒昌,男,博士研究生。主要研究方向:飞机复合材料结构修理。Tel.:010-82338873,E-mail:nhc1991@126.com;关志东,男,博士,教授,博士生导师。主要研究方向:飞机复合材料结构设计。Tel.:010-82338873,E-mail:zdguan@buaa.edu.cn

通讯作者:
关志东,Tel.:010-82338873,E-mail:zdguan@buaa.edu.cn

中图分类号: V214.8;TB330.1
计量
- 文章访问数: 824
- HTML全文浏览量: 129
- PDF下载量: 670
- 被引次数: 0
出版历程
- 收稿日期: 2015-10-26
- 修回日期: 2016-01-15
- 网络出版日期: 2016-11-20

Tensile behavior of scarf joints after impact in different locations

1.
School of Aeronautic Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100083, China
2. Beijing Aeronautical Science & Technology Research Institute, Commercial Aircraft Corporation of China, Ltd., Beijing 102211, China

摘要

摘要: 低速冲击损伤对复合材料胶接结构的力学性能存在威胁。对在搭接区域3个不同位置承受低速冲击的斜搭接接头进行冲击后拉伸试验，并分别建立胶接接头冲击及冲击后拉伸有限元模型。试验结果表明：冲击位置在搭接区尖端背侧，造成的凹坑深度最大，冲击后拉伸强度最低；冲击位置在搭接区中部，凹坑深度最小，冲击后拉伸强度最大；冲击位置在搭接区尖端侧，凹坑深度及冲击后拉伸强度居中。有限元分析结果表明胶层损伤和复合材料纤维损伤的大范围扩展是导致结构失效的主要原因。
- 复合材料结构 /
- 斜搭接接头 /
- 胶接连接 /
- 低速冲击 /
- 拉伸性能
Abstract: The damage introduced by low-velocity impact is a threat to composite bonded joints. Scarf joints were impacted in three different locations of joint areas and then tensile test after impact was conducted. Finite element models of impact and tensile after impact of scarf joints were established respectively. The test results demonstrate that when impact occurs at the back face of tips, the indentation depth is the largest and the tensile strength after impact is the lowest. When impact occurs at the middle of joint area, the indentation depth is the smallest and the tensile strength after impact is the highest. When impact occurs at the front face of tips, the indentation depth and tensile strength are medium. The finite element analysis results show that the major cause of structural failure is the extensive expansion of adhesive damage and fiber cracks.
- composite structure /
- scarf joints /
- adhesively bonded joints /
- low-velocity impact /
- tensile behavior

HTML全文

参考文献(17)

[1]	WU W Y,LIU Q,ZONG Z J,et al.Experimental investigation into transverse crashworthiness of CFRP adhesively bonded joints in vehicle structure[J].Composite Structures,2013,106:581-589.
[2]	谢鸣九.复合材料连接[M].上海:上海交通大学出版社,2011:24-25.XIE M J.Joints for composites materials[M].Shanghai:Shanghai Jiao Tong University Press,2011:24-25(in Chinese).
[3]	SAYMAN O,ARIKAN V,DOGAN A,et al. Failure analysis of adhesively bonded composite joints under transverse impact and different temperatures[J].Composites Part B:Engineering,2013,54:409-414.
[4]	GOH J Y,GEORGIADIS S,ORIFICI A C,et al.Effects of bondline flaws on the damage tolerance of composite scarf joints[J].Composites Part A:Applied Science and Manufacturing,2013,55:110-119.
[5]	CAMPILHO R D S G,DE MOURA M F S F,DOMINGUES J J M S.Modelling single and double-lap repairs on composite materials[J].Composites Science and Technology,2005,65(13):1948-1958.
[6]	HARMAN A B,WANG C H.Damage tolerance and impact resistance of composite scarf joints[C]//Proceedings of the 16th International Conference on Composite Materials,ICCM-16.Vancouver,BC:International Committee on Composite Materials,2007:1-12.
[7]	刘遂,关志东,郭霞,等.复合材料双搭接接头拉伸强度研究[J].航空材料学报,2012,32(5):86-91.LIU S,GUAN Z D,GUO X,et al.Tensile strength of composite double-lap joint[J].Journal of Aeronautical Materials,2012,32(5):86-91(in Chinese).
[8]	郭霞,关志东,刘遂,等.搭接长度对复合材料单搭接胶接接头的影响[J].科技导报,2013,31(7):37-41.GUO X,GUAN Z D,LIU S,et al.Effect of lap length on the adhesive-bonded single-lap composite joints[J].Science & Technology Review,2013,31(7):37-41(in Chinese).
[9]	乔玉,周光明,刘伟先,等.复合材料阶梯形胶接接头渐进损伤分析[J].南京航空航天大学学报,2014,46(4):632-637.QIAO Y,ZHOU G M,LIU W X,et al.Progressive damage analysis for stepped-lap joints of adhesive-bonded composite[J].Journal of Nanjing University of Aeronautics & Astronautics,2014,46(4):632-637(in Chinese).
[10]	刘凯.端部受冲击的胶接接头应力响应分析[D].宜昌:三峡大学,2013:62-63.LIU K.On the stress response of adhesively bonded joint under the Izod impact test[D].Yichang:China Three Gorges University,2013:62-63(in Chinese).
[11]	吴坤岳.基于内聚力模型的胶接结构疲劳特性研究[D].大连:大连理工大学,2013:60-61.WU K Y.Research on fatigue behavior of adhesive bonded structure based on cohesive zone model[D].Dalian:Dalian University of Technology,2013:60-61(in Chinese).
[12]	American Society for Testing and Materials Committiee.Standard test method for measuring the damage resistance of a fiber reinforced polymer matrix composite to a drop-weight impact event：ASTM D7136-07[S].Philadelphia:ASTM,2007.
[13]	沈真,张子龙,王进,等.复合材料损伤阻抗和损伤容限的性能表征[J].复合材料学报,2004,21(5):140-145.SHEN Z,ZHANG Z L,WANG J,et al.Characterization of damage resistance and damage tolerance behaviour of composite laminates[J].Acta Materiae Compositae Sinica,2004,21(5):140-145(in Chinese).
[14]	沈真,杨胜春,陈普会.复合材料层压板抗冲击行为及表征方法的实验研究[J].复合材料学报,2008,25(5):125-133.SHEN Z,YANG S C,CHEN P H.Experimental study on the behavior and characterization methods of composite laminates to withstand impact[J].Acta Materiae Compositae Sinica,2008,25(5):125-133(in Chinese).
[15]	ABAQUS Inc..Abaqus analysis user's manual,Volume IV:Elements[M].Providence,RI:Dassault Systemes Simulia Corp,2010:31.5.6-2-31.5.6-7.
[16]	杨小辉,胡坤镜,赵宁,等.内聚力界面单元在胶接接头分层仿真中的应用[J].计算机仿真,2010,27(10):317-320.YANG X H,HU K J,ZHAO N,et al.The simulation of the process of laminal damage in the adhesive bonded joint using the cohesive interface element[J].Computer Simulation,2010,27(10):317-320(in Chinese).
[17]	HASHIN Z.Failure criteria for unidirectional fiber composites[J].Journal of Applied Mechanics,1980,47(2):329-334.