Characterization of 3-D Surface Topography by Root-Mean-Square Wavelengt
-
摘要: 基于分形几何理论,通过分析随机粗糙表面的轮廓谱矩和表面谱矩的特性,提出了具有均一性和随机性的三维表面的均方根波长评定方法,并给出了理论推导及计算公式.还通过仿真模拟和对平面磨削试件的实测,验证了该方法的正确性.结论表明,对于不满足均一和随机性的表面,一般其加工纹理比较明显,可直接在垂直于加工纹理的方向上进行测量和评定,以此来表示三维表面的均方根波长.Abstract: Based on fractal geometry theory, a root-mean-square(RMS) wavelength method was proposed to quantitatively evaluate a 3D stochastic surface topography, by means of the surface spectral moments. Through DFT of the profile measured by a Talysurf-10 contact stylus instrument, we obtained the power spectrum and thefractal dimension of the profile. Further, the zero and 2nd order spectral moments of the profile and the surface were obtained. Using these parameters, the evaluation of RMS wavelength was conducted. By experiments for ground samples, the validity of the present method was confirmed.
-
Key words:
- surface roughness /
- evaluations /
- measurements /
- fractal dimension
-
[1]Dong W P, Sullivan P J, Stout K J. Comprehensive study of parameters for characterization 3-D surface topography-III[J]. Wear, 1994,178(1):29~43． [2]Dong W P, Sullivan P J, Stout K J. Comprehensive study of parameters for characterization 3-D surface topography-IV[J]. Wear, 1994,178(1):45~60． [3]强锡富,毛起广. 表面粗糙度及其测量译文集[M]. 北京:中国计量出版社, 1987. [4]李成贵,张国雄,袁长良. 三维表面粗糙度的等方性评定[J]. 机械工程学报,1999,35(1):15~19． [5]Majumdar A, Tien C L. Fractal characterization and simulation of rough surfaces[J]. Wear, 1990,136(2):313~317． [6]Thomas T R. Rough surface[M]. New York:Longman Press, 1982. -
点击查看大图
计量
- 文章访问数: 3134
- HTML全文浏览量: 166
- PDF下载量: 252
- 被引次数: 0
下载:
