微射流强化混合对喷流红外辐射特性的影响

朱希娟; 额日其太; 李家军; 王强

微射流强化混合对喷流红外辐射特性的影响

北京航空航天大学能源与动力工程学院, 北京 100191

详细信息

作者简介:
朱希娟(1981-),女,山东聊城人,博士生,zxj811129@163.com.

中图分类号: V 231.1
计量
- 文章访问数: 4126
- HTML全文浏览量: 114
- PDF下载量: 1026
- 被引次数: 0
出版历程
- 收稿日期: 2010-06-22
- 网络出版日期: 2011-04-30

Effect of micro-jets mixing enhancement on infrared radiation of plume

School of Jet Propulsion, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 计算了微射流强化混合喷流在3~5μm波段的红外辐射特性,并与无微射流强化混合的喷流红外辐射特性进行了比较,分析了微射流强化混合对喷流红外辐射特性的影响.喷流的流场及温度场结果采用有限体积法求解N-S方程得到,采用Tam-Thies湍流模型模拟喷流.红外辐射特性的计算采用有限体积法求解吸收-发射性介质条件下的三维辐射传输方程得到.计算结果表明,在中等亚音速条件下,微射流可以达到较好的强化混合效果,射流流量占主流流量1%时,喷流的红外辐射强度比基准喷流的红外辐射强度降低15%左右,射流流量达到主流流量的3%时,喷流的红外辐射强度可以降低27%左右.
- 微射流 /
- 强化混合 /
- 红外辐射 /
- 有限体积法
Abstract: The infrared radiation in 3~5μm band of the unforced plume and the forced plume which is mixed by injecting micro-jets into subsonic shear layer were calculated by a three-dimensional infrared(IR) radiation code of the plume, it was developed by the finite volume method (FVM) in non-gray absorbing-emitting media. The 3-D flow field of the jet was simulated numerically by FVM, Tam-Thies turbulence model. The results show that small injection flow rates (less than 3%) can make sharp increases in both velocity and temperature decay rates at middle Mach number. Compared with the unforced plume, when the jet mass flow accounts for 1% of the main flow, the IR radiation intensity of the forced plume is reduced by about 15%; and when the jet mass flow occupy 3%,the IR radiation intensity of the forced plume is decreased by about 27%.
- micro-jets /
- mixing enhancement /
- infrared radiation /
- finite volume method

HTML全文

参考文献(1)

[1] Wlezien R W,Kibens V.Influence of nozzle asymmetry on supersonic jets[J].AIAA J,1988,26(1):27-33 [2] Anjaneyulu K,James M,Donald B.Effect of slotting on the noise of an axisymmetric supersonic jet[J].AIAA J,1990,28:2136-2138 [3] 李家军,额日其太.脉冲射流强化圆柱喷流混合的三维数值模拟[J].北京航空航天大学学报,2007,33 (7):773-776 Li Jiajun,Eriqitai.Mixing enhancement in round jet exhaust using pulsed blowing:3-D numerical simulations [J].Journal of Beijing University of Aeronautics and Astronautics,2007,33(7):773-776(in Chinese) [4] 李挺,额日其太,李家军.微喷射流强化尾喷流混合的三维数值模拟[J].航空动力学报,2008,23(11):1966-1970 Li Ting,Eriqitai,Li Jiajun.Three dimensional numerical simulation of enhancing jet mixing with microjet[J].Journal of Aerospace Power,2008,23(11):1966-1970(in Chinese) [5] Chai J C,Lee H S,Patankar S V.Finite volume method for radiative heat transfer [J].J of Thermophysics and Heat Transfer,1994,8(3):419-425 [6] Chui E H,Raithby G D.Computation of radiant heat transfer on a nonorthogonal mesh using the finite volume method[J].Numerical Heat Transfer,Part B,1993,23:269-288 [7] 谈和平,夏新林,刘林华,等.红外辐射特性与传输的数值计算——计算热辐射学[M].哈尔滨:哈尔滨工业大学出版社,2006 Tan Heping,Xia Xinlin,Liu Linhua,et al.Numerical calculation of infrared radiation characteristics and transmission—calculation radiology [M].Harbin:Harbin Institute of Technology Press,2006(in Chinese) [8] 董士奎,余其铮,谈和平,等.燃烧产物二氧化碳高温辐射的窄谱带模型参数[J]．航空动力学报,2001,16(4):355-359 Dong Shikui,Yu Qizheng,Tan Heping,et al.Narrow band model parameters of high temperature radiation for carbon dioxide of combustion products[J].Journal of Aerospace Power,2001,16(4):355-359(in Chinese) [9] 董士奎,谈和平,余其铮,等.300~3000K水蒸气红外辐射谱带模型参数[J]．热能动力工程,2001,16(91):33-38 Dong Shikui,Tan Heping,Yu Qizhang,et al.Infrared radiative spectral band-model parameters for water vapor in the 300~3000K temperature range[J].Journal of Engineering for Thermal Energy and Power,2001,16(91):33-38(in Chinese) [10] Young S J.Nonisothermal band model theory [J].J of Quantitative Spectroscopy and Radiative Transfer,1976,18:1-28 [11] Ferziger J H,Peric M.Computational methods for fluid dynamics [M].Berlin:Springer,1996 [12] Behrouzi P,McGuirk J J.Jet mixing enhancement using fluid tabs[R].AIAA 2004-2401,2004

施引文献

资源附件(0)

访问统计