合成射流控制鼓包分离流动的数值模拟

陈占军; 巴玉龙; 王晋军

合成射流控制鼓包分离流动的数值模拟

北京航空航天大学航空科学与工程学院, 北京 100191

基金项目: 国家自然科学基金资助项目(50976007)

详细信息

中图分类号: V211.41⁺2
计量
- 文章访问数: 3194
- HTML全文浏览量: 292
- PDF下载量: 741
- 被引次数: 0
出版历程
- 收稿日期: 2011-06-18
- 网络出版日期: 2012-07-30

Numerical investigation on separation control for flow over a bump with synthetic jet

School of Aeronautic Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 为了研究合成射流控制鼓包背风面分离流动的效果,采用商用流体力学软件FLUENT^® 6.3求解Reynolds平均Navier-Stokes方程,通过分析鼓包壁面摩擦力系数分布、旋涡脱落结构以及射流孔口附近流动结构,揭示了合成射流对分离点不固定的流动分离的控制机理.结果表明:在分离点前施加合成射流可有效缩小回流区范围,涡脱落被施加的激励"锁定",涡脱落的频率等于合成射流的频率.此外,在本研究所考虑的情况下,动量系数越大,控制效果越好.从时均效果看,当施加最大吹气动量系数为0.369 1%的合成射流时,分离泡长度减小了11%.
- 合成射流 /
- 鼓包 /
- 流动控制 /
- 吹气动量系数
Abstract: Numerical simulation on the separation flow control over a bump was carried out with synthetic jet actuator before the separation point. The Reynolds averaged Navier-Stocks equations were solved by FLUENT^® 6.3. The mechanism of synthetic jet actuator flow separation control was discussed by analyzing the friction coefficient, the vortex structure separated from the bump and the flow field near the actuator orifice. When the synthetic jet actuator was turned on, the length of the recirculation region can be reduced, and the separation of flow was locked by synthetic jet, so the frequency of separation was equal to the frequency of synthetic jet. For the fixed actuating frequency, the larger the blowing momentum coefficients of the synthetic jet,the shorter the separation region downstream of the bump. When the maximum blowing momentum coefficient is 0.369 1%, the length of separation region can be reduced by 11%.
- synthetic jet /
- bump /
- flow control /
- blowing momentum coefficient

HTML全文

参考文献(17)

[1]	Smith B L,Swift G W.A comparison between synthetic jets and continuous jets[J].Experiments in Fluids,2003,34:467-472
[2]	Zhang P F,Wang J J,Feng L H.Reviews of zero-net-mass-flux jet and its application in separation flow control[J].Science In China E,2008:1315-1344
[3]	Britter R E,Hunt J C R,Richards K J.Air flow over a two-dimensional hill:studies of velocity speed-up,roughness effects and turbulence[J].Quart J Roy Meteorol Soc,1981,107(451):91-110
[4]	Vaccaro J,Vasile J,Amitay M.Active control of inlet ducts.AIAA 2008-6402,2008
[5]	Wellborn S R,Reichert B A,Okiishi T H.An experimental investigation of the flow in a diffusing S-duct.AIAA 1992-3622,1992
[6]	Vaccaro J C,Gressick W,Wen J,et al.An experimental investigation of flow control inside inlet ducts.AIAA 2009-740,2009
[7]	Reneaux J.Overview on drag reduction technologies for civil transport aircraft.ONERA-TP-04-153,2004
[8]	Dandois J,Garnier E.Numerical simulation of active separation control by a synthetic jet[J].Journal of Fluid Mechanics,2007,574:25-58
[9]	Greenblatt D,Paschal K B,Yao C S,et al.Separation control CFD validation test case part 1:baseline and steady suction.AIAA 2004-2220,2004
[10]	Greenblatt D,Paschal K B,Yao C S,et al.Separation control CFD validation test case part 2:zero efflux oscillatory blowing.AIAA 2005-485,2005
[11]	Rumsey C L.Successes and challenges for flow control simulations[J].International Journal of Flow Control,2009,1(1):1-27
[12]	ECCOMAS.Fifth European conference on computational fluid dynamics.Lisbon,Portugal:ECCOMAS,2004.www.maretec.ist.utl.pt/html_files/VV2010.htm
[13]	Dandois J,Garnier E.Numerical simulation of active separation control by a synthetic jet[J].Journal of Fluid Mechanics,2007,574:25-58
[14]	Smith B L,Glezer A.The formation and evolution of synthetic jets[J].Physics of Fluids,1998,10(9):2281-2297
[15]	Zhang P F,Wang J J.Novel signal wave pattern to generate more efficient synthetic jet[J].AIAA Journal,2007,45(5):1058-1065
[16]	Šari'c S,Jakirli'c S,Djugum A,et al.Computational analysis of locally forced flow over a wall-mounted hump at high-Re number[J].International Journal of Heat and Fluid Flow,2006,27(4):707-720
[17]	Hamstra J W,Miller D N,Truax P P,et al.Active inlet flow control technology demonstration[J].Aeronautical Journal,2000,104(1040):473-479