模拟海洋环境中两种结构钢焊接接头腐蚀特性

于美; 王瑞阳; 刘建华; 李松梅

模拟海洋环境中两种结构钢焊接接头腐蚀特性

北京航空航天大学材料科学与工程学院, 北京 100191

基金项目: 国家自然科学基金资助项目(51171011)

详细信息

中图分类号: TG172
计量
- 文章访问数: 1575
- HTML全文浏览量: 315
- PDF下载量: 624
- 被引次数: 0
出版历程
- 收稿日期: 2012-08-30
- 修回日期: 2012-11-29
- 网络出版日期: 2013-08-30

Corrosion properties of two kinds of hull steels welding joints in simulated marine environments

School of Materials Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

摘要

摘要: 采用周浸实验模拟海水周期浸润环境,中性盐雾实验模拟海洋大气环境,加以恒载荷拉伸应力条件研究了10CrNi3MoV和12MnSiNiCrMo两种结构钢焊接接头的腐蚀特性,并测试分析了其焊接接头各处的动电位极化曲线.通过金相分析研究了两种钢焊缝区、热影响区与母材的显微组织差别.结果表明:两种钢的焊缝区较母材更易发生腐蚀,应力腐蚀断裂位置均位于焊缝区,且焊缝区腐蚀电流密度最大,母材最小;10CrNi3MoV钢焊接接头的耐蚀性能要好于12MnSiNiCrMo钢,在较低和较高应力水平下10CrNi3MoV钢焊接接头的耐应力腐蚀性能也优于12MnSiNiCrMo钢,同时12MnSiNiCrMo钢各区腐蚀电流密度都远大于10CrNi3MoV钢.焊接后不同区域金相组织的差别是造成上述现象的原因,母材区适量的针状铁素体能够保持其强韧性和耐蚀性,焊缝区过量的铁素体则导致其耐蚀性和耐应力腐蚀性能降低.
- 10CrNi3MoV /
- 12MnSiNiCrMo /
- 焊接接头 /
- 腐蚀特性
Abstract: Corrosion properties of 10CrNi3MoV and 12MnSiNiCrMo welding joints were investigated by alternate immersion test, neutral salt spray test and constant load tensile stress corrosion test. These tests were designed to simulate circulatory soakage of seawater and marine atmosphere respectively. Dynamic polarization curves of the welding joints were tested too. Microstructures of the weld zone, heat affected zone and base metal were analyzed by metallographic technique. The results show that the weld zone is more liable to corrosion and more sensitive to fracture. The corrosion current density of weld zone is the biggest while the base metal is the smallest for both two welding joints. The corrosion resistance of 10CrNi3MoV is much better than 12MnSiNiCrMo. When the stress level is comparatively lower or higher, the welding joints of 12MnSiNiCrMo are more susceptible to stress corrosion cracking than 10CrNi3MoV. The corrosion current density of the welding joints of 12MnSiNiCrMo is much bigger than 10CrNi3MoV. Microstructure differences of different zones are the main reason. Proper amount of acicular ferrite maintains the obdurability corrosion resistance of base metal, but the resistance to corrosion and stress corrosion cracking is declined by superfluous ferrite in the weld zone.
- 10CrNi3MoV /
- 12MnSiNiCrMo /
- welding joints /
- corrosion property

HTML全文

参考文献(1)

[1] 杨敏.船舶制造基础[M].北京:国防工业出版社,2005 Yang Min.Ship manufacturing foundation[M].Beijing:National Defense Industry Press,2005(in Chinese) [2] 杨才福,苏航,李丽,等.高性能铜沉淀硬化船体钢[J].中国有色金属学报,2004,14(增刊1):211-216 Yang Caifu,Su Hang,Li Li,et al.High performance copper-precipitation-hardened ship hull steel[J].The Chinese JournaI of Nonferrous Metals,2004,14(Supplement 1):211-216(in Chinese) [3] Mujahid M,Lis A K,Garcia C I,et al.HSLA-100 steels:influence of aging heat treatment on microstructure and properties[J].Journal of Materials Engineering and Performance,1998,7(2):247-257 [4] Banerjee K,Chatterjee U K.Effect of microstructure on hydrogen Embrittlement of weld-simulated HSLA-80 and HSLA-100 steels[J].Metallurgical and Materials Transactions A,2003,34(6):1297-1309 [5] Bandyopadhyay P S,Kundu S,Ghosh S K,et al.Structure and properties of a low-carbon,microalloyed,ultra-high-strength steel[J].Metallurgical and Materials Transactions A,2011,42(4):1051-1061 [6] 常娥,闫永贵,李庆芬,等.阴极极化对921A钢海水中氢脆敏感性的影响[J].中国腐蚀与防护学报,2010,30(1):83-88 Chang E,Yan Yonggui,Li Qingfen,et al.Effects of cathodic polarization on the hydrogen embrittlement sensitivity of 921A steel in seawater[J].Journal of Chinese Society for Corrosion and Protection,2010,30(1):83-88(in Chinese) [7] 黄晓艳,刘波.舰船用结构材料的现状与发展[J].船舶,2004(3):21-25 Huang Xiaoyan,Liu Bo.Current situation and development of warship structure material[J].Ship & Boat,2004(3):21-25(in Chinese) [8] 柴峰.低合金高强度船舶钢焊接热影响区韧化机理研究[D].上海:上海交通大学材料科学与工程学院,2008 Chai Feng.Study on toughening mechanism of heat-affected zone of low alloy high strength marine steel[D].Shanghai:School of Materials Science and Engineering,Shanghai Jiao Tong University,2008(in Chinese) [9] Spanos G.Microstructure change in HSLA-100 steel thermally cycled to simulate the heat-affected zone during welding[J].Metallurgical and Materials Transactions A,1995,26A(12):3227-3293 [10] Thompson S W.Continuous-cooling-transformation behavior in HSLA 80 steel[J].Metallurgical and Materials Transactions,1996,27A(6):1557-1571 [11] Beidokhti B,Dolati A,Koukabi A H.Effect of alloying elements and microstructure on the susceptibility of the welded HSLA steel to hydrogen-induced cracking and sulfide stress cracking[J].Materials Science & Engineering,2009,50(7):167-173 [12] 王素华,朱梅五,孔小东,等.两种船体钢焊接接头耐海水腐蚀性能对比[J].焊接学报,2001,22(4):69-72 Wang Suhua,Zhu Meiwu,Kong Xiaodong,et al.Comparison of the seawater corrosion resistant performance of two kinds of ship hull steel weld joints[J].Transactions of the China Welding Institution,2001,22(4):69-72(in Chinese) [13] 黄安国,李志远,余圣甫,等.低合金钢焊缝金属的腐蚀行为[J].焊接学报,2005,26(11):30-35 Huang Anguo,Li Zhiyuan,Yu Shengfu,et al.Corrosion behavior of low alloy steel weldment[J].Transactions of the China Welding Institution,2005,26(11):30-35(in Chinese) [14] 王治宇,韩俭,宋红梅,等.双相不锈钢不同电弧焊接方法的接头性能对比分析[J].焊接学报,2011,32(4):37-40 Wang Zhiyu,Han Jian,Song Hongmei,et al.Comparative analysis of the performance about double phase stainless steel in different arc welding method of joint[J].Transactions of the China Welding Institution,2011,32(4):37-40(in Chinese) [15] 曾华波.船体钢海水全浸区腐蚀的室内模拟加速试验方法的研究[D].长沙:湖南大学应用化学学院,2010 Zeng Huabo.Study on laboratory simulation accelerated testing methods of marine steel corrosion in seawater immersion[D].Changsha:School of Applied Chemistry,Hunan University,2010 (in Chinese) [16] 许小平,周飞霓,卢本.船舶钢结构焊接技术[M].北京:机械工业出版社,2009 Xu Xiaoping,Zhou Feini,Lu Ben.Welding technology of marine structure steels[M].Beijing:China Machine Press,2009(in Chinese) [17] Huang H H,Wen T T,Lee J T.The influence of microstructure and composition on the electrochemical behavior of A516 steel weldment[J].Corrosion Science,1994,36(6):1027-1038 [18] Deen K M,Ahmad R,Khan I H,et al.Microstructural study and electrochemical behavior of low alloy steel weldment[J].Materials & Design,2010,31(6):3051-3055 [19] Krishnan K N,Rao K P.Effect of microstructure on stress corrosion cracking behaviour of austenitic stainless steel weld metals[J].Materials Science and Engineering:A,1991,142(1,15):79-85

施引文献

资源附件(0)

访问统计