Citation: | WANG Zimeng, JIAO Zongxia, LI Xingluet al. Matching design rules of linear-driven electro-hydrostatic actuator[J]. Journal of Beijing University of Aeronautics and Astronautics, 2018, 44(5): 1037-1047. doi: 10.13700/j.bh.1001-5965.2017.0304(in Chinese) |
Electro-hydrostatic actuator (EHA) is a highly integrated pump controlled transmission system, and it has been successfully applied to A380 and F35 to drive main flight control surface. However, the traditional EHA composed by rotary motor and axial piston pump has limited dynamic response. This paper introduces a novel linear-driven electro-hydrostatic actuator (LEHA) with fast dynamic response, and studies the parameter design rules of LEHA. The key feature of LEHA is the novel linear pump with collaborative rectification principle. Pistons and valve spools in collaborative rectification pump are directly driven by linear motor. The parameter design rules of LEHA are firstly considered from the static index matching rules, and the constraint conditions of the maximum no-load speed, the constraint condition of the maximum static output force and the constraint condition of the maximum pressure of the system are deduced. According to LEHA's mathematic model, the influence of each parameter on the bandwidth of the LEHA is analyzed, and the dynamic performance design rule of LEHA is obtained, which is the constraint condition of the LEHA bandwidth index to the resonance frequency of the linear motor. The power constraint condition of LEHA is analyzed finally, and the power envelope condition of LEHA for inertial load, elastic load and viscous damping load is given in the output force-velocity coordinates, from which the power matching design rule of the LEHA is obtained. In conclusion, the 6 matching design constraints of LEHA parameter design rule can provide a theoretical basis for the design process of LEHA.
[1] |
WHEELER P, BOZHKO S.The more electric aircraft:Technology and challenges[J].IEEE Electrification Magazine, 2014, 2(4):6-12. doi: 10.1109/MELE.2014.2360720
|
[2] |
WHEELER P. Technology for the more and all electric aircraft of the future[C]//IEEE International Conference on Automatica. Piscataway, NJ: IEEE Press, 2016: 1-5.
|
[3] |
SARLIOGLU B, MORRIS C T.More electric aircraft:Review, challenges, and opportunities for commercial transport aircraft[J].IEEE Transactions on Transportation Electrification, 2015, 1(1):54-64. doi: 10.1109/TTE.2015.2426499
|
[4] |
DERRIEN J C, SECURITE S D. Electro-mechanical actuator (EMA) advanced technologies for flight controls[C]//28th International Congress of the Aeronautical Sciences, 2012: 1-10.
|
[5] |
ALLE N, HIREMATH S S, MAKARAM S, et al.Review on electro hydrostatic actuator for flight control[J].International Journal of Fluid Power, 2016, 17(2):125-145. doi: 10.1080/14399776.2016.1169743
|
[6] |
BOTTEN S L, WHITLEY C R, KING A D.Flight control actuation technology for next-generation all-electric aircraft[J].Technology Review Journal, 2000, 23(6):55-68.
|
[7] |
CHAKRABORTY I, TRAWICK D R, JACKSON D, et al. Electric control surface actuator design optimization and allocation for the more electric aircraft[C]//2013 Aviation Technology, Integration, and Operations Conference. Reston: AIAA, 2013: 4283.
|
[8] |
VAN DEN BOSSCHE D. The A380 flight control electro-hydrostatic actuators, achievements and lessons learnt[C]//25th International Congress of the Aeronautical Sciences, 2006: 1-8.
|
[9] |
ANDERSON J A. Variable displacement electro-hydrostatic actuator[C]//IEEE Aerospace and Electronics Conference. Piscataway, NJ: IEEE Press, 1991: 529-534.
|
[10] |
SHEN W, MAI Y, SU X, et al.A new electric hydraulic actuator adopted the variable displacement pump[J].Asian Journal of Control, 2016, 18(1):178-191. doi: 10.1002/asjc.v18.1
|
[11] |
JIANG J H, LIU Q, LIU J L, et al.Performance comparison of displacement and speed control in electro-hydrostatic actuator[J].Applied Mechanics and Materials, 2015, 779:205-211. doi: 10.4028/www.scientific.net/AMM.779
|
[12] |
HANKAN C, TUNA B, BULENT E P. A complete analysis for single rod electro hydrostatic actuators[C]//10th International Fluid Power Conference. Dresden: IFAS, 2016: 119-132.
|
[13] |
NAVARRO R. Performance of an electro-hydrostatic actuator on the F-18 systems research aircraft: NASA/TM-97-206224[R]. Edwards: Dryden Flight Research Center, 1997: 1-37.
|
[14] |
MCCULLOUGH. Design and characterization of a dual electro-hydrostatic actuator[D]. Hamilton: McMaster University, 2011: 4-11.
|
[15] |
ANDERSON E, LINDLER J. Smart material actuator with long stroke and high power output[C]//43rd Structures, Structural Dynamics, and Materials Conference. Reston: AIAA, 2002: 1354.
|
[16] |
JOHN S, SIROHI J, WANG G, et al.Comparison of piezoelectric, magnetostrictive, and electrostrictive hybrid hydraulic actuators[J].Journal of Intelligent Material Systems and Structures, 2007, 18(10):1035-1048. doi: 10.1177/1045389X06072355
|
[17] |
KAN J, TANG K, REN Y, et al.Study on a piezohydraulic pump for linear actuators[J].Sensors and Actuators A:Physical, 2009, 149(2):331-339. doi: 10.1016/j.sna.2008.12.008
|
[18] |
CHAUDHURI A, WERELEY N M.Experimental validation of a hybrid electrostrictive hydraulic actuator analysis[J].Journal of Vibration and Acoustics, 2010, 132(2):021006. doi: 10.1115/1.4000778
|
[19] |
KIM G W, WANG K W.Helmholtz resonance in a piezoelectric-hydraulic pump-based hybrid actuator[J].Smart Materials and Structures, 2010, 20(1):015010.
|
[20] |
TAN H, HURST W, LEO D.Performance modeling of a piezohydraulic actuation system with active valves[J].Smart Materials and Structures, 2004, 14(1):91-110.
|
[21] |
LI Y, JIAO Z, YAN L, et al.Conceptual design and composition principles analysis of a novel collaborative rectification structure pump[J].Journal of Dynamic Systems, Measurement, and Control, 2014, 136(5):054507. doi: 10.1115/1.4027504
|
[22] |
LIANG H, JIAO Z, YAN L, et al.Design and analysis of a tubular linear oscillating motor for directly-driven EHA pump[J].Sensors and Actuators A:Physical, 2014, 210:107-118. doi: 10.1016/j.sna.2014.01.026
|
[1] | GAO S,LI Y H,SUN F Q. Design and optimization of warranty period of new products with two-parameter degradation[J]. Journal of Beijing University of Aeronautics and Astronautics,2025,51(6):2137-2147 (in Chinese). doi: 10.13700/j.bh.1001-5965.2023.0316. |
[2] | YANG B C,HAN J F. Optimization of key parameters of electromagnetic coil launching based on uniform design experimentation[J]. Journal of Beijing University of Aeronautics and Astronautics,2025,51(2):440-445 (in Chinese). doi: 10.13700/j.bh.1001-5965.2023.0040. |
[3] | LI Jingyu, HAN Xudong, FU Yongling, ZHAO Jiang'ao. Cascade Sliding Mode Control of Electro-Hydrostatic Actuators Based on Multi-Disturbance Parallel Estimation and Compensation[J]. Journal of Beijing University of Aeronautics and Astronautics. doi: 10.13700/j.bh.1001-5965.2025.0154 |
[4] | XU J Q,LIN H P,GUO H. Multi-layer wave-shaped topology and thermal design method for aero-electric propulsion motors[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(6):1806-1818 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0498. |
[5] | YUAN Y,LIU J,YU J Q,et al. Aerodynamic layout optimization design of high-speed folding-wing vehicles[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(11):3410-3416 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0849. |
[6] | LAI J Y,GUAN W Q,LUO G Z,et al. Design of rectangular cross-section spring anti-reverse device for a certain type of aviation[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(6):1868-1876 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0750. |
[7] | CAI Qingzhu, LIU Qiang. An efficient Swin Transformer accelerator design[J]. Journal of Beijing University of Aeronautics and Astronautics. doi: 10.13700/j.bh.1001-5965.2024.0222 |
[8] | YANG R R,ZHANG L,ZHAO J L,et al. Nonlinear variable damping integral sliding mode control for electro-hydrostatic actuator[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(1):163-172 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0252. |
[9] | SHAO Z Z,ZHENG K,DONG S,et al. Design of double bending rotary ultrasonic elliptical vibration machining system[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(9):2912-2918 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0712. |
[10] | FANG Zhen, XIE Yongqi, CHEN Lijun, PENG Zheng, LI Guoguang, ZHANG Hongxing. Design and experimental investigation on the heat transfer performance of a dual compensation chamber flat loop heat pipe[J]. Journal of Beijing University of Aeronautics and Astronautics. doi: 10.13700/j.bh.1001-5965.2024.0613 |
[11] | ZHANG W,GAO Z H,WANG C,et al. Efficient surrogate-based aerodynamic optimization with parameter-free adaptive penalty function[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(4):1262-1272 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0451. |
[12] | ZHANG Hua-bo, GUO Ying-qing, LI Gui-cai, ZHAO Wan-li, YE Peng. Modeling and parameter design methodology for component-level performance model of ducted ram air generation turbine[J]. Journal of Beijing University of Aeronautics and Astronautics. doi: 10.13700/j.bh.1001-5965.2023.0787 |
[13] | GE Wenqing, LI Detong, SONG Yadong, TAN Cao, LI Bo. Displacement sensorlesscontrol of electromagnetic linear actuator based on improved sliding mode observer[J]. Journal of Beijing University of Aeronautics and Astronautics. doi: 10.13700/j.bh.1001-5965.2024.0291 |
[14] | CHEN H T,SU Z K,LI C T,et al. Trajectory design for straight-circulating flight transition of aerial recovery towing system[J]. Journal of Beijing University of Aeronautics and Astronautics,2024,50(8):2565-2574 (in Chinese). doi: 10.13700/j.bh.1001-5965.2022.0692. |
[15] | LIU Yanbin, WANG Xuesheng, QIN Xinya, WANG Hao, CHEN Qinzhu, ZHAO Sai. Design and characteristics of reverse direct-acting high-pressure reducing valve for pneumatic actuator[J]. Journal of Beijing University of Aeronautics and Astronautics, 2022, 48(7): 1164-1173. doi: 10.13700/j.bh.1001-5965.2021.0292 |
[16] | KANG Rui, LIU Haoran, ZHANG Qingyuan, YU Li, ZHAI Guofu. Function oriented belief reliability design and optimization of new torsion spring electrical connectors[J]. Journal of Beijing University of Aeronautics and Astronautics, 2022, 48(9): 1745-1756. doi: 10.13700/j.bh.1001-5965.2022.0323 |
[17] | WU Yue, XIE Changchuan, YANG Chao, An Chao. Optimal design of motion parameters of flapping wing[J]. Journal of Beijing University of Aeronautics and Astronautics, 2022, 48(7): 1324-1331. doi: 10.13700/j.bh.1001-5965.2021.0593 |
[18] | Wang Bingjie, Zhao Junpeng, Wang Chunjie. Spatial straightness error evaluation based on three-dimensional least squares method[J]. Journal of Beijing University of Aeronautics and Astronautics, 2014, 40(10): 1477-1480. doi: 10.13700/j.bh.1001-5965.2013.0644 |
[19] | Guo Hongwei, Liu Rongqiang, Deng Zongquan. Performance parameters analysis and design of space cable-strut deployable articulated mast[J]. Journal of Beijing University of Aeronautics and Astronautics, 2008, 34(10): 1186-1190. |
[20] | Li Zhongming, Jiao Zongxia, Wang Kejun. Optimum design of erecting system[J]. Journal of Beijing University of Aeronautics and Astronautics, 2007, 33(02): 176-179. |