北京航空航天大学学报 ›› 2014, Vol. 40 ›› Issue (3): 389-393.doi: 10.13700/j.bh.1001-5965.2013.0252

• 论文 • 上一篇    下一篇

两种用于NS-DSMC耦合方法的连续失效参数对比

唐振宇, 蔡国飙   

  1. 北京航空航天大学 宇航学院, 北京 100191
  • 收稿日期:2013-05-10 出版日期:2014-03-20 发布日期:2014-03-29

Comparison analysis between two continuum breakdown parameters applied in coupled NS-DSMC method

Tang Zhenyu, Cai Guobiao   

  1. School of Astronautics, Beijing University of Aeronautics and Astronautics, Beijing 100191, China
  • Received:2013-05-10 Online:2014-03-20 Published:2014-03-29

摘要: NS-DSMC(Navier Stokes-Direct Simulation Monte Carlo)耦合方法是计算连续-稀薄跨流域流动的主要方法,应用过程中如何确定连续流域和稀薄流域的界面是此方法的关键问题之一,界面位置通常通过连续失效参数来判定.为合理选择连续失效参数,对目前广泛使用的两种连续失效参数KnQ和B参数进行了理论上的分析和比较,表明虽然他们建立的出发点不同,但在数学形式上具有一定相似性.通过圆柱绕流问题的数值试验进一步验证了两种连续失效参数具有一定对应关系.KnQB两种连续失效参数在NS-DSMC耦合方法中应用效果相差不大,但KnQ 的阈值0.05适用范围较广,而B参数的阈值对不同流动问题会有变化.

Abstract: Navier Stokes-direct simulation Monte Carlo (NS-DSMC) coupled method is a principal method for the computation of continuum-rarefied transitional gas flows. How to locate the interface between continuum and rarefied domains is one of the key aspects in using this method, which is generally achieved by applying a continuum breakdown parameter. To choose the continuum breakdown parameter more reasonably, theoretical analysis and comparisons were carried out for two major continuum breakdown parameters: KnQ and B, which show that they have similar mathematical forms to a certain extent, although they are established from different basis. Numerical test was conducted by using an over-cylinder flow problem which also indicates the relationship between them. KnQ and B parameters have few differences when applied in NS-DSMC coupled method, except that KnQ parameter has a widely used threshold value of 0.05, but the threshold value of B parameter will vary for different flows.

中图分类号: 


版权所有 © 《北京航空航天大学学报》编辑部
通讯地址:北京市海淀区学院路37号 北京航空航天大学学报编辑部 邮编:100191 E-mail:jbuaa@buaa.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发